NOTE: During configuration or flashing a device, the only that should be hooked to the device is the computer and power.

 This section is in need of cleanup!

Platform

Serial Num. = ?
FCC ID = MQ4WAP2102
CPU Type = Atheros AR2317-AC1A B48218C 0622 (AR2317)
MIPS Rev = ?
CPU Speed = 180MHz
Bus = ?
Flash Type = Serial
Flash Chip = MX X070929 25L3205AMC-20G 2T850200
Flash Size = 4MB
Max Firmware Size = ?
RAM Size = 16MB
RAM Chip = ISSI IS42S16800A-7TL FA682618D 0645
nvram Size = ?
Switch = N/A
Port-based vlan = ?
802.1q vlan = ?
Ethernet Port Count = 1-10/100-LAN
Wired Standard = IEEE 802.3/3u
boot_wait = ?
bootloader = ?
Flash Card Socket/Type = No
SD/MMC Mod Support = No
MiniPCI slots = No
PoE = ?
Power = 3.3V/1.5A
Color of LEDs = ?
Size = ?
USB = No
Serial Port = Yes
JTAG Port = No
Supported by TJTAG/Version = No
Supported by dd-wrt as of = MF54G2 v.24 pre sp2 - build 12110
dd-wrt K2.4 Support = ?
dd-wrt K2.6 Support = ?
Special Features = Planex GW-MF54G2 Clone

Radio (ath0)

Wireless Radio = Atheros
WLAN DSP processor = ?
Antenna Connector Type = Single Detachable Dipole 2dBi Antenna
Wireless Standard = IEEE 802.11b/g
WiFi Operating Frequency = 2.412GHz-2.4835GHz
 802.11g = 6, 9, 12, 18, 24, 36, 48, 54Mbps
 802.11b = 1, 2, 5.5, 11Mbps
Radio cor_rev = ?
Radio Capabilities = ?

• planex GW-MF54G2(AboCom WAP2102) one more AR231x works fine. - OpenWRT

 This section is in need of cleanup!

 This section is in need of cleanup!

 This section is in need of cleanup!

No JTAG

Serial PinoutsEdit

 This section is in need of cleanup!

Hyper terminal Setup in Windows XPEdit

In Windows XP, Click Start Button - All Programs - Accessories - 
   Communication - HyperTerminal
Enter a name for the connection, Click ok
Choose com port you adapter is plugged into, Click ok
Set:
 Bits per second = 115200
 Data Bits = 8
 Parity = none
 Stop bits = 1
 Flow control = none
Click ok
Click File - Save As, and select a place to save it to so you 
             don't have to enter the settings again.

Putty Setup in Windows XPEdit

After installing putty, run it
 Serial line = The COM port your using for serial (ie. COM3)
 Speed = 115200
Click on Serial under Connection
 Serial line to connect to = same as above (Serial line)
 Speed (baud) = 115200
 Data bits = 8
 Stop bits = 1
 Parity = None
 Flow control = None
Click Session
 Enter a name for your connection under saved sessions
Click Save
Click Open

Serial RecoveryEdit

 This section is in need of Serial Recovery Instructions!

 This section is in need of cleanup!

See Planex GW-MF54G2 FCC Pictures