Your here: Home / Network / Hardware Specific / Airlive / WLA-9000AP
 |
This article is a stub. Please help InfoDepot Wiki by expanding it, adding pictures, and improving existing text.
|
| File:Airlive_WLA-9000APa.jpg |
NOTE: Activation Required.
NOTE: During configuration or flashing a device, the only that should be hooked to the device is the computer and power.
Specs[]
This section is in need of cleanup!
Platform
Serial Num. = ? FCC ID = ? CPU Type = Atheros AR5312 MIPS Rev = ? CPU Speed = 220MHz Bus = ? Flash Type = Parallel Flash Chip = ? Flash Size = 8MB Max Firmware Size = 7995392 bytes RAM Size = 32MB RAM Chip = ? nvram Size = ? Switch = M 88E6061-LAJ1 B56991.2 1642 A1P Port-based vlan = ? 802.1q vlan = ? Ethernet Port Count = 1-WAN 2-LAN Wired Standard = IEEE 802.3?/3af boot_wait = ? bootloader = ? Flash Card Socket/Type = No SD/MMC Mod Support = No MiniPCI slots = No PoE = Yes Power = 5.5V/2.5A Color of LEDs = ? Size = ? USB = No Serial Port = Yes JTAG Port = Yes Supported by TJTAG/Version = ? Supported by dd-wrt as of = v.24 SP2 - build 11003 dd-wrt K2.4 Support = Yes dd-wrt K2.6 Support = No Special Features = ?
Radio
Wireless Radio = Atheros WLAN DSP processor = ? Antenna Connector Type = ? Wireless Standard = IEEE 802.11b/g/n WiFi Operating Frequency = ? 802.11n Draft = up to 300Mbps 802.11g = 6, 9, 12, 18, 24, 36, 48, 54Mbps 802.11b = 1, 2, 5.5, 11Mbps Radio cor_rev = ? Radio Capabilities = ?
Links of Interest[]
Flashing[]
This section is in need of cleanup!
Upgrading[]
This section is in need of cleanup!
Reverting[]
This section is in need of cleanup!
JTAG/Serial Info[]
JTAG[]
JTAG Pinouts[]
This section is in need of cleanup!
JTAG Recovery[]
This section is in need JTAG Recovery Instructions!
Serial[]
Serial Pinouts[]
o1 VCC o2 RXD o3 N/C o4 N/C o5 TXD o6 GND
Hyper terminal Setup in Windows XP[]
In Windows XP, Click Start Button - All Programs - Accessories -
Communication - HyperTerminal
Enter a name for the connection, Click ok
Choose com port you adapter is plugged into, Click ok
Set:
Bits per second = 115200
Data Bits = 8
Parity = none
Stop bits = 1
Flow control = none
Click ok
Click File - Save As, and select a place to save it to so you
don't have to enter the settings again.
Putty Setup in Windows XP[]
After installing putty, run it Serial line = The COM port your using for serial (ie. COM3) Speed = 115200 Click on Serial under Connection Serial line to connect to = same as above (Serial line) Speed (baud) = 115200 Data bits = 8 Stop bits = 1 Parity = None Flow control = None Click Session Enter a name for your connection under saved sessions Click Save Click Open
Serial Recovery[]
This section is in need of Serial Recovery Instructions!
vlan Info[]
This section is in need of cleanup!
Pictures[]
FCC Pictures[]
This section is in need of cleanup!
Notes[]
Hardware Modification[]