NOTE: During configuration or flashing a device, the only that should be hooked to the device is the computer and power.

This section is in need of cleanup!

Platform
Serial Num. = 12113
FCC ID = ?
Industry Canada ID = 
CPU Type = Broadcom BCM5358UB0KFBG (SoC)
MIPS Rev = ?
CPU Speed = ?
Bus = ?
Flash Type = SPI Flash
Flash Chip = MXIC MX, 25L6406E
Flash Size = 8MB
Max Firmware Size = ?
RAM Size = ?
RAM Chip = ?
nvram Size = ?
Switch = Broadcom BCM5358UB0KFBG (SoC)
Port-based vlan = ?
802.1q vlan = ?
Ethernet Port Count = 0-10/100-WAN 4-10/100-LAN
Wired Standard = IEEE 802.3?
boot_wait = ?
bootloader = Uboot
Flash Card Socket/Type = No
SD/MMC Mod Support = No
MiniPCI slots = No
PoE = No
Power = 12V/1A
Color of LEDs = 1 x network status LED, 1 x WPS LED
Size = ?
USB = 1x USB2.0
Serial Port = Yes
JTAG Port = Yes
Supported by TJTAG/Version = ?
Special Features = ?

Radio

Wireless Radio = Broadcom BCM5358UB0KFBG (SoC)
WLAN DSP processor = ?
Antenna Connector Type = 2x2, Internal
Wireless Standard = IEEE 802.11b/g/n
WiFi Operating Frequency = 2.4Ghz
802.11n = up to 300Mbps
802.11g = 6, 9, 12, 18, 24, 36, 48, 54Mbps
802.11b = 1, 2, 5.5, 11Mbps
Radio cor_rev = ?
Radio Capabilities = ?

Radio

Wireless Radio = Broadcom BCM43236KMLG
WLAN DSP processor = ?
Antenna Connector Type = 2x2, Internal
Wireless Standard = IEEE 802.11a/n
WiFi Operating Frequency = 5Ghz
802.11n = up to 300Mbps
802.11a = 6, 9, 12, 18, 24, 36, 48, 54Mbps
Radio cor_rev = ?
Radio Capabilities = ?

This section is in need of cleanup!

This section is in need of cleanup!

This section is in need of cleanup!

JTAG port J2: 14 pole

Serial PinoutsEdit

J3:

Front
VCC 1 o
RX  2 o
TX  3 o
GND 4 o
Rear

Hyper terminal Setup in Windows XPEdit

In Windows XP, Click Start Button - All Programs - Accessories -
Communication - HyperTerminal
Enter a name for the connection, Click ok
Choose com port you adapter is plugged into, Click ok
Set:
Bits per second = 115200
Data Bits = 8
Parity = none
Stop bits = 1
Flow control = none
Click ok
Click File - Save As, and select a place to save it to so you
don't have to enter the settings again.

Putty Setup in Windows XPEdit

After installing putty, run it
Serial line = The COM port your using for serial (ie. COM3)
Speed = 115200
Click on Serial under Connection
Serial line to connect to = same as above (Serial line)
Speed (baud) = 115200
Data bits = 8
Stop bits = 1
Parity = None
Flow control = None
Click Session
Enter a name for your connection under saved sessions
Click Save
Click Open

Serial RecoveryEdit

 This section is in need of Serial Recovery Instructions!

This section is in need of cleanup!

This section is in need of cleanup!