Your here: Home / Network / Hardware Specific / Cisco-Linksys / Cisco Valet M10 v2.0
This article is a stub. Please help InfoDepot Wiki by expanding it, adding pictures, and improving existing text.
|
File:Cisco Valet M10 v1.0a.jpg Wireless HotSpot Router |
NOTES: To flash from stock firmware, follow the link HERE. After flashing and doing a 30/30/30, you will then be able to flash a more current build of either TOASTMAN or SHIBBY
Specs[]
This section is in need of cleanup!
Platform
Serial Num. = ? FCC ID = Q87-M10V2 CPU Type = Broadcom BCM5357 MIPS Rev = ? CPU Speed = 300MHz Bus = ? Flash Type = Serial Flash Chip = ? Flash Size = 4MB Max Firmware Size = ? RAM Size = 32MB RAM Chip = ? nvram Size = ? Switch = ? Port-based vlan = ? 802.1q vlan = ? Ethernet Port Count = 1-WAN 4-LAN Wired Standard = IEEE 802.3? boot_wait = ? bootloader = CFE Flash Card Socket/Type = No SD/MMC Mod Support = No MiniPCI slots = No PoE = No Power = ? Color of LEDs = ? Size = 7.95" x 6.30" x 1.34" USB = No Serial Port = Yes JTAG Port = Yes Supported by TJTAG 3.02 = ? Supported by dd-wrt as of = WIP Special Features = ?
Radio (wl0)
Wireless Radio = Broadcom WLAN DSP processor = Broadcom Antenna Connector Type = Internal Wireless Standard = IEEE 802.11b/g/n WiFi Operating Frequency = 2.4 GHz 802.11n Draft = up to 300Mbps 802.11g = 6, 9, 12, 18, 24, 36, 48, 54Mbps 802.11b = 1, 2, 5.5, 11Mbps Radio cor_rev = ? Radio Capabilities = ?
Links of Interest[]
Flashing[]
Upgrading[]
Reverting[]
JTAG/Serial Info[]
JTAG[]
JTAG Pinouts[]
This section is in need of cleanup!
JTAG Recovery[]
This section is in need JTAG Recovery Instructions!
Serial[]
Serial Pinouts[]
This section is in need of cleanup!
Hyper terminal Setup in Windows XP[]
In Windows XP, Click Start Button - All Programs - Accessories - Communication - HyperTerminal Enter a name for the connection, Click ok Choose com port you adapter is plugged into, Click ok Set: Bits per second = 115200 Data Bits = 8 Parity = none Stop bits = 1 Flow control = none Click ok Click File - Save As, and select a place to save it to so you don't have to enter the settings again.
Putty Setup in Windows XP[]
After installing putty, run it Serial line = The COM port your using for serial (ie. COM3) Speed = 115200 Click on Serial under Connection Serial line to connect to = same as above (Serial line) Speed (baud) = 115200 Data bits = 8 Stop bits = 1 Parity = None Flow control = None Click Session Enter a name for your connection under saved sessions Click Save Click Open
Serial Recovery[]
This section is in need of Serial Recovery Instructions!