Fandom

InfoDepot Wiki

Linksys E1000 v2.0

1,124pages on
this wiki
Add New Page
Talk0 Share

Your here: Home / Network / Hardware Specific / Cisco-Linksys / E1000 v2.0


Linksys E1000 v2.0
Linksys E1000a
Wireless-N Router

Homepage

E1000

Wikipedia

Linksys E1000

WikiDevi

Linksys E1000 v2.0

dd-wrt

Linksys E1000 v2.0

OpenWRT

Status Unknown

Tomato

Status Unknown

TomatoUSB

Status Unknown

Gargoyle

Status Unknown

NOTE: Requires K2.6, Do not flash anything else.
NOTE: During configuration or flashing a device, the only things that should be hooked to the device is the computer and power.

SpecsEdit

Fixme This section is in need of cleanup!

Platform

Serial Num. = CVN1
FCC ID = Q87-E1000V2
CPU Type = Broadcom BCM5357B0KFBG (BCM5357B)
MIPS Rev = ?
CPU Speed = 300MHz
Bus = ?
Flash Type = Serial
Flash Chip = MX 25L3205D
Flash Size = 4MB
Max Firmware Size = 3801088 bytes
RAM Size = 32MB
RAM Chip = Hynix H5DU2562GTR
nvram Size = 32kb
Switch = Broadcom BCM5357B0KFBG (BCM5357B)
Port-based vlan = ?
802.1q vlan = ?
Ethernet Port Count = 1-10/100-WAN 4-10/100-LAN
Wired Standard = IEEE 802.3/3u
boot_wait = ?
bootloader = CFE
Flash Card Socket/Type = No
SD/MMC Mod Support = No
MiniPCI slots = No
PoE = No
Power = 12V/0.5A
Color of LEDs = ?
Size = 7.95" x 1.34" x 6.3" (202 x 34 x 160 mm)
USB = No
Serial Port = Yes
JTAG Port = Yes
Supported by TJTAG 3.02 = ?
Supported by dd-wrt as of = 16758
dd-wrt K2.4 Support = No
dd-wrt K2.6 Support = Yes
Special Features = ?

Radio (wl0)

Wireless Radio = Broadcom BCM5357B0KFBG (BCM5357B)
WLAN DSP processor = Broadcom BCM5357B0KFBG (BCM5357B)
Antenna Connector Type = Internal
Wireless Standard = IEEE 802.11b/g/n
WiFi Operating Frequency = 2.4GHz
 802.11n Draft = up to 300Mbps
 802.11g = 6, 9, 12, 18, 24, 36, 48, 54Mbps
 802.11b = 1, 2, 5.5, 11Mbps
Radio cor_rev = ?
Radio Capabilities = ?

Links of InterestEdit

FlashingEdit

Fixme This section is in need of cleanup!

UpgradingEdit

Fixme This section is in need of cleanup!

RevertingEdit

Fixme This section is in need of cleanup!

JTAG/Serial InfoEdit

JTAGEdit

JTAG PinoutsEdit
Fixme This section is in need of cleanup!
JTAG RecoveryEdit
Fixme This section is in need JTAG Recovery Instructions!

SerialEdit

Serial PinoutsEdit
Fixme This section is in need of cleanup!
Hyper terminal Setup in Windows XPEdit
In Windows XP, Click Start Button - All Programs - Accessories - 
   Communication - HyperTerminal
Enter a name for the connection, Click ok
Choose com port you adapter is plugged into, Click ok
Set:
 Bits per second = 115200
 Data Bits = 8
 Parity = none
 Stop bits = 1
 Flow control = none
Click ok
Click File - Save As, and select a place to save it to so you 
             don't have to enter the settings again.
Putty Setup in Windows XPEdit
After installing putty, run it
 Serial line = The COM port your using for serial (ie. COM3)
 Speed = 115200
Click on Serial under Connection
 Serial line to connect to = same as above (Serial line)
 Speed (baud) = 115200
 Data bits = 8
 Stop bits = 1
 Parity = None
 Flow control = None
Click Session
 Enter a name for your connection under saved sessions
Click Save
Click Open
Serial RecoveryEdit
Fixme This section is in need of Serial Recovery Instructions!

PicturesEdit

Pic's from barryware.

Linksys E1000b Linksys E1000c Linksys E1000d

Linksys E1000e Linksys E1000f Linksys E1000g

FCC PicturesEdit

Linksys E1000 v2.0 FCCa Linksys E1000 v2.0 FCCb Linksys E1000 v2.0 FCCc

Linksys E1000 v2.0 FCCd

With Switch SampleEdit

Linksys E1000 v2.0 FCCe ws Linksys E1000 v2.0 FCCf ws Linksys E1000 v2.0 FCCg ws

Linksys E1000 v2.0 FCCh ws Linksys E1000 v2.0 FCCi ws Linksys E1000 v2.0 FCCj ws

Linksys E1000 v2.0 FCCk ws Linksys E1000 v2.0 FCCl ws

Without Switch SampleEdit

Linksys E1000 v2.0 FCCm wos Linksys E1000 v2.0 FCCn wos Linksys E1000 v2.0 FCCo wos

Linksys E1000 v2.0 FCCp wos Linksys E1000 v2.0 FCCq wos Linksys E1000 v2.0 FCCr wos

NotesEdit


Hardware ModificationEdit


Ad blocker interference detected!


Wikia is a free-to-use site that makes money from advertising. We have a modified experience for viewers using ad blockers

Wikia is not accessible if you’ve made further modifications. Remove the custom ad blocker rule(s) and the page will load as expected.